Gold nanoparticles assembled with dithiocarbamate-anchored molecular wires – University of Copenhagen

Center for Synthetic Biology > New Publications > Gold nanoparticles ass...

23 October 2015

Gold nanoparticles assembled with dithiocarbamate-anchored molecular wires

Reeler, N.E.A., Lerstrup, K.A., Somerville, W., Speder, J., Petersen, S.V., Laursen, B.W., Arenz, M., Qiu, X., Vosch, T, and Nørgaard, K.  Scientific Reports 5, 15273 doi:10.1038/srep15273 (2015) I.F. 5.597

Abstract

A protocol for the bottom-up self-assembly of nanogaps is developed through molecular linking of gold nanoparticles (AuNPs). Two π-conjugated oligo(phenylene ethynylene) molecules (OPE) with dithiocarbamate anchoring groups are used as ligands for the AuNPs. OPE-4S with a dithiocarbamate in each end of the molecule and a reference molecule OPE-2S with only a single dithiocarbamate end group. The linking mechanism of OPE-4S is investigated by using a combination of TEM, UV-Vis absorption and surface enhanced Raman spectroscopy (SERS) as well as studying the effect of varying the OPE-4S to AuNP concentration ratio. UV-Vis absorption confirms the formation of AuNP aggregates by the appearance of an extended plasmon band (EPB) for which the red shift and intensity depend on the OPE-4S:AuNP ratio. SERS confirms the presence of OPE-4S and shows a gradual increase of the signal intensity with increasing OPE-4S:AuNP ratios up to a ratio of about 4000, after which the SERS intensity does not increase significantly. For OPE-2S, no linking is observed below full coverage of the AuNPs indicating that the observed aggregate formation at high OPE-2S:AuNP ratios, above full AuNP coverage, is most likely of a physical nature (van der Waals forces or π-π interactions).

Read the full article here